Allied Telesis CentreCOM FS980M/9 Command Reference Manual page 332

I C
NTERFACE OMMANDS
SHOW INTERFACE STATUS
Table 4: Parameters in the output from the show interface status command
Related show interface
Commands
show interface memory
613-50157-01 Rev C
Parameter Description
Port
Name/Type of the interface.
Name
Description of the interface.
Status
The administrative and operational status of the interface; one of:
• disabled: the interface is administratively down.
• connect: the interface is operationally up.
• notconnect: the interface is operationally down.
Vlan
VLAN type or VLAN IDs associated with the port:
• When the VLAN mode is trunk, it displays trunk (it does not
• When the VLAN mode is access, it displays the VLAN ID.
• When the VLAN mode is private promiscuous, it displays the
• When the VLAN mode is private host, it displays the primary
• When the port is an Eth port, it displays none: there is no VLAN
• When the VLAN is dynamically assigned, it displays the current
Duplex
The actual duplex mode of the interface, preceded by a- if it has
autonegotiated this duplex mode. If the port is disabled or not
connected, it displays the configured duplex setting.
Speed
The actual link speed of the interface, preceded by a- if it has
autonegotiated this speed. If the port is disabled or not
connected, it displays the configured speed setting.
Type
The type of interface, e.g. 1000BaseTX. For SFP bays, it displays
Unknown if it does not recognize the type of SFP installed, or Not
present if an SFP is not installed or is faulty.
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
display the VLAN IDs).
primary VLAN ID if it has one, and promiscuous if it does not
have a VLAN ID.
and secondary VLAN IDs.
associated with it.
dynamically assigned VLAN ID (not the access VLAN ID), or
dynamic if it has multiple VLANs dynamically assigned.
332