Access-List (Numbered Hardware Acl For Icmp) - Allied Telesis CentreCOM FS980M/9 Command Reference Manual

IP 4 H A C
V ARDWARE CCESS ONTROL
- (
ACCESS LIST NUMBERED HARDWARE
access-list (numbered hardware ACL for
ICMP)
Overview This command creates an access-list for use with hardware classification. The
access-list will match on ICMP packets that have the specified source and
destination IP addresses and, optionally, ICMP type. You can use the value any
instead of source or destination address if an address does not matter.
Once you have configured the ACL, you can use the
access-group
The optional vlan parameter can be used to match tagged (802.1q) packets.
The no variant of this command removes the previously specified access-list.
access-list <3000-3699> <action> icmp <source-ip> <dest-ip>
Syntax
[icmp-type <number>] [vlan <1-4094>]
no access-list <3000-3699>
613-50157-01 Rev C
L (ACL) C
IST OMMANDS
ACL ICMP)
FOR
command to apply this ACL to a port or QoS class-map.
Parameter Description
<3000-3699>
An ID number for this hardware IP access-list.
<action>
The action that the switch will take on matching packets:
deny
permit
send-to-cpu
icmp
Match against ICMP packets
<source-ip>
The source addresses to match against. You can specify a single
host, a subnet, or all source addresses. The following are the valid
formats for specifying the source:
any
host <ip-addr>
<ip-addr>/<prefix>
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
access-group or the
Reject packets that match the source
and destination filtering specified
with this command.
Permit packets that match the source
and destination filtering specified
with this command.
Send matching packets to the CPU.
Match any source IP address.
Match a single source host with the
IP address given by <ip-addr> in
dotted decimal notation.
Match any source IP address within
the specified subnet. Specify the
subnet by entering the IPv4 address,
then a forward slash, then the prefix
length.
match
762