Auth Log - Allied Telesis CentreCOM FS980M/9 Command Reference Manual

A C
UTHENTICATION OMMANDS

AUTH LOG

auth log
Overview Use this command to configure the types of authentication feature log messages
that are output to the log file.
Use the no variant of this command to remove either specified types or all types of
authentication feature log messages that are output to the log file.
Syntax auth log {dot1x|auth-mac|auth-web}
{success|failure|logoff|all}
no auth log {do1x|auth-mac|auth-web}
{success|failure|logoff|all}
Default All types of authentication log messages are output to the log file by default.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port; or Authentication Profile mode.
Examples To configure the logging of MAC authentication failures to the log file for
supplicants (client devices) connected to interface port1.0.2, use the following
commands:
awplus#
awplus(config)#
awplus(config-if)#
613-50157-01 Rev C
Parameter Description
dot1x
Specify only 802.1X-Authentication log messages are output to the log
file.
auth-mac
Specify only MAC-Authentication log messages are output to the log
file.
auth-web
Specify only Web-Authentication log messages are output to the log
file.
success
Specify only successful authentication log messages are output to the
log file.
failure
Specify only authentication failure log messages are output to the log
file.
logoff
Specify only authentication log-off messages are output to the log file.
Note that link down, age out and expired ping polling messages will be
included.
all
Specify all types of authentication log messages are output to the log
file Note that this is the default behavior for the authentication logging
feature.
configure terminal
interface port1.0.2
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
auth log auth-mac failure
959