Loop-Protection Action-Delay-Time - Allied Telesis CentreCOM FS980M/9 Command Reference Manual

S C
WITCHING OMMANDS
- -
LOOP PROTECTION ACTION DELAY

loop-protection action-delay-time

Overview Use this command to sets the loop protection action delay time for an interface to
specified values in seconds. The action delay time specifies the waiting period for
the action.
Use the no variant of this command to reset the loop protection action delay time
for an interface to default.
loop-protection action-delay-time <0-86400>
Syntax
no loop-protection action
Default Action delay timer is disabled by default.
Mode Interface Configuration
Example To configure a loop protection action delay time of 10 seconds on port 1.0.4, use
the commands:
awplus#
awplus(config)#
awplus(config-if)#
Related show loop-protection
Commands
613-50157-01 Rev C
-
TIME
Parameter Description
<0-86400>
Time in seconds; 0 means action delay timer is disabled.
configure terminal
interface port1.0.4
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
loop-protection action-delay-time 10
367