Allied Telesis CentreCOM FS980M/9 Command Reference Manual page 326

I C
NTERFACE OMMANDS
SHOW INTERFACE
Figure 9-1:
awplus#show interface
Interface port1.0.1
Scope: both
Link is DOWN, administrative state is UP
Thrash-limiting
Status Not Detected, Action learn-disable, Timeout 1(s)
Hardware is Ethernet, address is eccd.6dff.d67d
index 5001 metric 1 mru 1500
configured duplex auto, configured speed auto, configured polarity auto
<UP,BROADCAST,MULTICAST>
SNMP link-status traps: Disabled
input packets 0, bytes 0, dropped 0, multicast packets 0
output packets 0, bytes 0, multicast packets 0 broadcast packets 0
Time since last state change: 0 days 01:37:41
...
To display configuration and status information for interface lo, use the
command:
awplus#
Figure 9-2:
awplus#show interface lo
Interface lo
Scope: both
Link is UP, administrative state is UP
Hardware is Loopback
index 1 metric 1
<UP,LOOPBACK,RUNNING>
SNMP link-status traps: Disabled
input packets 0, bytes 0, dropped 0, multicast packets 0
output packets 0, bytes 0, multicast packets 0 broadcast packets 0
Time since last state change: 69 days 01:28:47
To display configuration and status information for interfaces vlan1 and vlan2,
use the command:
awplus#
613-50157-01 Rev C
Example output from the show interface command
show interface lo
Example output from the show interface lo command
show interface vlan1,vlan2
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
326