Allied Telesis CentreCOM FS980M/9 Command Reference Manual page 947

A C
UTHENTICATION OMMANDS
-
AUTH AUTH FAIL VLAN
as a supplicant on the Guest VLAN. For more information about ACL concepts, and
configuring ACLs see the
more information about ACL commands see:
•
•
•
Examples To enable the auth-fail vlan feature for port1.0.2 and assign VLAN 100, use the
following commands:
awplus#
awplus(config)#
awplus(config-if)#
To disable the auth-fail vlan feature for port1.0.2, use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
To enable the auth-fail vlan feature on authentication profile 'student', use the
commands:
awplus#
awplus(config)#
awplus(config-auth-profile)#
To disable the auth-fail vlan feature on authentication profile 'student', use the
commands:
awplus#
awplus(config)#
awplus(config-auth-profile)#
Related auth profile (Global Configuration)
Commands
dot1x max-auth-fail
show dot1x
show dot1x interface
show running-config
613-50157-01 Rev C
ACL Feature Overview and Configuration
IPv4 Hardware Access Control List (ACL) Commands
IPv4 Software Access Control List (ACL) Commands
IPv6 Software Access Control List (ACL) Commands
configure terminal
interface port1.0.2
auth auth-fail vlan 100
configure terminal
interface port1.0.2
no auth auth-fail vlan
configure terminal
auth profile student
configure terminal
auth profile student
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
auth auth-fail vlan 100
no auth auth-fail vlan
Guide. For
947