Allied Telesis CentreCOM FS980M/9 Command Reference Manual page 806

IP 4 S A C
V OFTWARE CCESS ONTROL
- ( )
ACCESS LIST EXTENDED NAMED
Table 25-2: Parameters in the access-list extended (named) command - icmp
613-50157-01 Rev C
L (ACL) C
IST OMMANDS
Parameter Description
<source>
The source address of the packets. You can specify a single host, a
subnet, or all sources. The following are the valid formats for
specifying the source:
any
host<ip-addr>
<ip-addr>/
<prefix>
<ip-addr>
<reverse-mask>
<destination>
The destination address of the packets. You can specify a single
host, a subnet, or all destinations. The following are the valid
formats for specifying the destination:
any
host<ip-addr>
<ip-addr>/
<prefix>
<ip-addr>
<reverse-mask>
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
Matches any source IP address.
Matches a single source host with the
IP address given by <ip-addr> in
dotted decimal notation.
An IPv4 address, followed by a forward
slash, then the prefix length. This
matches any source IP address within
the specified subnet.
Alternatively, you can enter a reverse
mask in dotted decimal format. For
example, entering 192.168.1.1
0.0.0.255 is the same as entering
192.168.1.1/24.
Matches any destination IP address.
Matches a single destination host with
the IP address given by <ip-addr> in
dotted decimal notation.
An IPv4 address, followed by a forward
slash, then the prefix length. This
matches any destination IP address
within the specified subnet.
Alternatively, you can enter a reverse
mask in dotted decimal format. For
example, entering 192.168.1.1
0.0.0.255 is the same as entering
192.168.1.1/24.
806