Allied Telesis CentreCOM FS980M/9 Command Reference Manual page 786

IP 4 H A C
V ARDWARE CCESS ONTROL
( ACL: IP
NAMED HARDWARE PACKET ENTRY
Then use the
to a port or QoS class-map. Note that the ACL will only apply to incoming data
packets.
You can use ACLs to redirect packets, by sending them to the CPU. Use such ACLs
with caution. They could prevent control packets from reaching the correct
destination, such as EPSR healthcheck messages and VCStack messages.
Examples To add a filter entry to the access-list named "my-list" that will permit any IP packet
with a source address of 192.168.1.1, use the commands:
awplus#
awplus(config)#
awplus(config-ip-hw-acl)#
To add a filter entry to the access-list named "my-list" that will permit any IP packet
with a source address of 192.168.1.1and a MAC source address of ffee.ddcc.bbaa,
use the commands:
awplus#
awplus(config)#
awplus(config-ip-hw-acl)#
ffee.ddcc.bbaa 0000.0000.0000 any
To add a filter entry to the access-list named "my-list" that will deny all IP packets
on vlan 2, use the commands:
awplus#
awplus(config)#
awplus(config)#
awplus(config-ip-hw-acl)#
Related access-group
Commands
access-list hardware (named hardware ACL)
match access-group
show running-config
show access-list (IPv4 Hardware ACLs)
613-50157-01 Rev C
L (ACL) C
IST OMMANDS
)
access-group
configure terminal
access-list hardware my-list
configure terminal
access-list hardware my-list
enable
configure terminal
access-list hardware my-list
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
or the match access-group
permit ip 192.168.1.1/32 any
permit ip 192.168.1.1/32 any mac
deny ip any any vlan 2
command to apply this ACL
786