Dot1X Timeout Tx-Period - Allied Telesis CentreCOM FS980M/9 Command Reference Manual

802.1X C
OMMANDS
1 -
DOT X TIMEOUT TX PERIOD

dot1x timeout tx-period

Overview This command sets the transmit timeout for the authentication request on the
specified interface.
The no variant of this command resets the transmit timeout period to the default
(30 seconds).
Syntax dot1x timeout tx-period <1-65535>
no dot1x timeout tx-period
Default The default transmit period for port authentication is 30 seconds.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port; or Authentication Profile mode.
Usage Use this command to set the interval between successive attempts to request an
ID.
To set the transmit timeout period to 5 seconds on interface port1.0.2, use the
Examples
commands:
awplus#
awplus(config)#
awplus(config-if)#
To reset transmit timeout period to the default (30 seconds) on interface
port1.0.2, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
To set the transmit timeout period to 5 seconds on authentication profile 'student',
use the commands:
awplus#
awplus(config)#
awplus(config-auth-profile)#
To reset transmit timeout period to the default (30 seconds) on authentication
profile 'student', use the commands:
awplus#
awplus(config)#
awplus(config-auth-profile)#
613-50157-01 Rev C
Parameter Description
<1-65535>
Seconds.
configure terminal
interface port1.0.2
configure terminal
interface port1.0.2
configure terminal
auth profile student
configure terminal
auth profile student
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
dot1x timeout tx-period 5
no dot1x timeout tx-period
dot1x timeout tx-period 5
no dot1x timeout tx-period
922