Allied Telesis CentreCOM FS980M/9 Command Reference Manual page 769

IP 4 H A C
V ARDWARE CCESS ONTROL
- (
ACCESS LIST NUMBERED HARDWARE
Table 24-3: Parameters in access-list (hardware IP numbered) (cont.)
Table 24-4: IP protocol number and description
613-50157-01 Rev C
L (ACL) C
IST OMMANDS
ACL IP )
FOR PROTOCOLS
Parameter Description
<ip-addr>/<prefix> Match any source IP address within
<ip-addr>
<reverse-mask>
<dest-ip>
The destination addresses to match against. You can specify a
single host, a subnet, or all destination addresses. The following
are the valid formats for specifying the destination:
any
host <ip-addr>
<ip-addr>/<prefix> Match any destination IP address
<ip-addr>
<reverse-mask>
vlan <1-4094>
The VLAN to match against. The ACL will match against the
specified ID in the packet's VLAN tag.
Protocol Number Protocol Description [RFC]
1 Internet Control Message [RFC792]
2 Internet Group Management [RFC1112]
3 Gateway-to-Gateway [RFC823]
4 IP in IP [RFC2003]
5 Stream [RFC1190] [RFC1819]
6 TCP (Transmission Control Protocol) [RFC793]
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
the specified subnet. Specify the
subnet by entering the IPv4 address,
then a forward slash, then the prefix
length.
Match any source IP address within
the specified subnet. Specify the
subnet by entering a reverse mask in
dotted decimal format. For example,
entering "192.168.1.1 0.0.0.255" is
the same as entering 192.168.1.1/24.
Match any destination IP address.
Match a single destination host with
the IP address given by <ip-addr> in
dotted decimal notation.
within the specified subnet. Specify
the subnet by entering the IPv4
address, then a forward slash, then
the prefix length.
Match any destination IP address
within the specified subnet. Specify
the subnet by entering a reverse
mask in dotted decimal format. For
example, entering "192.168.1.1
0.0.0.255" is the same as entering
192.168.1.1/24.
769