Allied Telesis CentreCOM FS980M/9 Command Reference Manual page 562

P E C
OWER OVER THERNET OMMANDS
-
SHOW POWER INLINE
Table 1: Parameters in the show power-inline command output (cont.)
Related show power-inline counters
Commands
show power-inline interface
613-50157-01 Rev C
Parameter
Device
Class
Max (mW)
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
Description
The description of the connected PD device if a description
has been added with the
command. No description is shown for PDs not configured
with the power-inline description
The class of the connected PD, if power is being supplied to
the PD.
The power in milliwatts (mW) allocated for the PoE port.
Additionally, note the following as displayed per PoE port:
• [U] if the power limit for a port was user configured (with
the power-inline max
• [L] if the power limit for a port was supplied by LLDP.
• [C] if the power limit for a port was supplied by the PD
class.
power-inline description
command.
command).
562