Ip Igmp Snooping Report-Suppression - Allied Telesis CentreCOM FS980M/9 Command Reference Manual

IGMP S C
NOOPING OMMANDS
-
IP IGMP SNOOPING REPORT SUPPRESSION

ip igmp snooping report-suppression

Overview Use this command to enable report suppression for IGMP versions 1 and 2. This
command applies to interfaces configured for IGMP Snooping.
Report suppression stops reports being sent to an upstream multicast router port
when there are already downstream ports for this group on this interface.
Use the no variant of this command to disable report suppression.
ip igmp snooping report-suppression
Syntax
no ip igmp snooping report-suppression
Default Report suppression does not apply to IGMPv3, and is turned on by default for
IGMPv1 and IGMPv2 reports.
Mode Interface Configuration for a VLAN interface.
Example To enable report suppression for IGMPv2 reports for vlan2, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
Related show ip igmp interface
Commands
show running-config
613-50157-01 Rev C
configure terminal
interface vlan2
ip igmp version 2
ip igmp snooping report-suppression
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
713