Show Dot1X Supplicant Interface - Allied Telesis CentreCOM FS980M/9 Command Reference Manual

802.1X C
OMMANDS
1
SHOW DOT X SUPPLICANT INTERFACE

show dot1x supplicant interface

Overview This command shows the supplicant state of the authentication mode set for the
interface, which may be a static channel (or static aggregator) or a dynamic (or
LACP) channel group or a switch port.
This command shows a summary when the optional brief parameter is used.
For information on filtering and saving command output, see the
with AlliedWare_Plus" Feature Overview and Configuration
show dot1x supplicant interface <interface-list> [brief]
Syntax
Mode Privileged Exec
See sample output below showing the supplicant on the interface port1.0.6:
Examples
awplus#
613-50157-01 Rev C
Parameter
<interface-list>
brief
show dot1x interface port1.0.6
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
Description
The interfaces or ports to configure. An interface-list can be:
• an interface (e.g. vlan2), a switch port (e.g. port1.0.6),
a static channel group (e.g. sa2) or a dynamic (LACP)
channel group (e.g. po2)
• a continuous range of interfaces, ports, static channel
groups or dynamic (LACP) channel groups separated by a
hyphen; e.g. vlan2-8, or port1.0.1-1.0.4, or
sa1-2, or po1-2
• a comma-separated list of the above; e.g.
port1.0.1,port1.0.4-1.0.6. Do not mix interface
types in a list
The specified interfaces must exist.
Brief summary of the Supplicant state.
"Getting Started
Guide.
939