Allied Telesis CentreCOM FS980M/9 Command Reference Manual page 429

VLAN C
OMMANDS
SWITCHPORT TRUNK ALLOWED VLAN
either the except or the all parameters have first been used to add a list of VLANs to a
port.
To remove a VLAN, where the configuration for port1.0.6 shows the below
output:
Remove VLAN 3 by re-entering the except parameter with the list of VLANs to
remove, instead of using the remove parameter, as shown in the command
example below:
awplus#
awplus(config)#
awplus(config-if)#
Then the configuration is changed after entering the above commands to remove
VLAN 3:
To add a VLAN, where the configuration for port1.0.6 shows the below output:
613-50157-01 Rev C
awplus#show running-config

!
interface port1.0.6
switchport
switchport mode trunk
switchport trunk allowed vlan except 4
configure terminal
interface port1.0.6
awplus#show running-config

!

interface port1.0.6
switchport
switchport mode trunk
switchport trunk allowed vlan except 3-4
awplus#show running-config

!

interface port1.0.6
switchport
switchport mode trunk
switchport trunk allowed vlan except 3-5
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
switchport trunk allowed vlan except 3,4
429