Mls Qos Map Premark-Dscp To - Allied Telesis CentreCOM FS980M/9 Command Reference Manual

Q S C
O OMMANDS
-
MLS QOS MAP PREMARK DSCP TO

mls qos map premark-dscp to

Overview This command configures the premark-dscp map. It is used when traffic is
classified by a class-map that has
the map determines new QoS settings for the traffic.
The no variant of this command resets the premark-dscp map to its defaults. If no
DSCP is specified then all DSCP entries will be reset to their defaults.
mls qos map premark-dscp <0-63> to [new-queue <0-4>]
Syntax
no mls qos map premark-dscp [<0-63>]
Mode Global Configuration
Usage With the
enables you to specify the queue for packets.
When
priority) value to determine queue settings for traffic egressing that port.
Therefore, non-IP packets will not be prioritized on that port. Non-IP packets will all
go into queue 0.
Example To send packets to queue 2 if they have a DSCP of 34, use the commands:
awplus#
awplus(config)#
To reset the entry for DSCP 1 use the command:
Example
awplus#
awplus(config)#
Related show mls qos maps premark-dscp
Commands
trust dscp
613-50157-01 Rev C
Parameter
premark-dscp <0-63>
new-queue <0-3>
trust dscp command set, the mls qos map premark-dscp command
trust dscp is enabled on a port, the switch cannot use the CoS (802.1p
configure terminal
mls qos map premark-dscp 34 to new-queue 2
configure terminal
no mls qos map premark-dscp 1
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
trust dscp configured. Based on a lookup DSCP,
Description
The DSCP value on ingress.
Modify Egress Queue.
872