Allied Telesis CentreCOM FS980M/9 Command Reference Manual page 234

P C C
LUGGABLES AND ABLING OMMANDS
SHOW SYSTEM PLUGGABLE DETAIL
•
NOTE
instead.
Example To display detailed information about the pluggable transceivers installed in a
particular port on the device, use a command like:
To display detailed information about all the pluggable transceivers installed on
the device, use the command:
awplus#
Output Figure 6-2:
Table 6-1: Parameters in the output from show system pluggable detail
613-50157-01 Rev C
Power Monitoring: Displays the received power measurement type, which
can be either OMA(Optical Module Amplitude) or Avg(Average Power)
measured in μW.
: For parameters that are not supported or not specified, a hyphen is displayed
show system pluggable detail
Example output from show system pluggable detail for a specific
port on a device
awplus#show system pluggable port1.0.5 detail
System Pluggable Information Detail

Stack member 1

port1.0.27
==========
Vendor Name:
Device Name:
Device Revision:
Device Type:
Serial Number:
Manufacturing Datecode:
SFP Laser Wavelength:
Link Length Supported
Single Mode Fiber :
OM1 (62.5um) Fiber:
OM2 (50um) Fiber
OM3 (50um) Fiber
Diagnostic Calibration:
Power Monitoring:
Parameter
Port
Vendor Name
Device Name
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
TE Connectivity
AT-StackXS/1.0
B
1xCOPPER PAS
13140191
13040300
256nm
-
-
: -
: -
-
-
Description
Specifies the port the pluggable transceiver is installed in.
Specifies the vendor's name for the installed pluggable
transceiver.
Specifies the device name for the installed pluggable
transceiver.
234