Allied Telesis CentreCOM FS980M/9 Command Reference Manual page 831

IP 4 S A C
V OFTWARE CCESS ONTROL
( -
ACCESS LIST STANDARD NAMED FILTER
Usage An ACL can be configured with multiple ACL filters using sequence numbers. If the
sequence number is omitted, the next available multiple of 10 will be used as the
sequence number for the new filter. A new ACL filter can be inserted into the
middle of an existing list by specifying the appropriate sequence number.
NOTE
standard (named)
further parameters selected.
Software ACLs will deny access unless explicitly permitted by an ACL action.
Use the following commands to add a new filter entry to access-list my-list that
Examples
will reject IP address 10.1.1.1:
awplus#
awplus(config)#
awplus(config-ip-std-acl)#
Use the following commands to insert a new filter entry into access-list my-list
at sequence position number 15 that will accept IP network 10.1.2.0:
awplus#
awplus(config)#
awplus(config-ip-std-acl)#
Related access-list standard (named)
Commands
show running-config
show ip access-list
613-50157-01 Rev C
L (ACL) C
IST OMMANDS
)
: The access control list being configured is selected by running the
command with the required access control list name, but with no
configure terminal
access-list standard my-list
configure terminal
access-list standard my-list
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
deny 10.1.1.1/32
15 permit 10.1.2.0/24
access-list
831