Allied Telesis CentreCOM FS980M/9 Command Reference Manual page 434

VLAN C
OMMANDS
SWITCHPORT VOICE VLAN
"Egress-VLAN-Name (58)" in the RADIUS Accept message when authenticating a
phone attached to this port.
For more information about configuring authentication for Voice VLAN, see the
LLDP Feature Overview and Configuration
If the ports have been set to be edge ports by the
the no variant of this command will leave them unchanged as edge ports. To set
them back to their default non-edge port configuration, use the
edgeport (RSTP and MSTP)
To tell IP phones connected to port1.0.5 to send voice data tagged for VLAN
Examples
10, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
To tell IP phones connected to ports 1.0.2-1.0.6 to send priority tagged packets
(802.1p priority tagged with VID 0, so that they will be assigned to the port VLAN)
use the following commands. The priority value is 5 by default, but can be
configured with the
awplus#
awplus(config)#
awplus(config-if)#
To dynamically configure the VLAN ID advertised to IP phones connected to
port1.0.1 based on the VLAN assigned by RADIUS authentication (with RADIUS
attribute "Egress- VLANID" or "Egress-VLAN-Name" in the RADIUS accept packet),
use the commands:
awplus#
awplus(config)#
awplus(config-if)#
To remove the Voice VLAN, and therefore disable the transmission of LLDP-MED
network policy information for voice devices on port1.0.6, use the following
commands:
awplus#
awplus(config)#
awplus(config-if)#
613-50157-01 Rev C
command.
configure terminal
interface port1.0.5
switchport voice vlan 10
switchport voice vlan priority
configure terminal
interface port1.0.2-port1.0.6
switchport voice vlan dot1p
configure terminal
interface port1.0.1
switchport voice vlan dynamic
configure terminal
interface port1.0.6
no switchport voice vlan
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
Guide.
switchport voice vlan
spanning-tree
command.
command,
434