Dot1X Initialize Interface - Allied Telesis CentreCOM FS980M/9 Command Reference Manual

802.1X C
OMMANDS
1
DOT X INITIALIZE INTERFACE

dot1x initialize interface

Overview This command removes authorization for a specified connected interface. The
connection will attempt to re-authorize when the specified port attempts to make
use of the network connection.
NOTE
the reauthorization attempt is not triggered by this command. The attempt is triggered
by the first packet from the interface trying to access the network resources.
dot1x initialize interface <interface-list>
Syntax
Mode Privileged Exec
To initialize 802.1X port authentication on the interface port1.0.2, use the
Examples
command:
awplus#
To unauthorize switch port1.0.1 and attempt reauthentication on switch
port1.0.1, use the command:
awplus#
Validation show dot1x
Commands
show dot1x interface
Related dot1x initialize supplicant
Commands
613-50157-01 Rev C
: Reauthentication could be a long time after the use of this command because
Parameter
<interface-list> The interfaces or ports to configure. An interface-list can be:
dot1x initialize interface port1.0.2
dot1x initialize interface port1.0.1
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
Description
• an interface (e.g. vlan2), a switch port (e.g. port1.0.6),
a static channel group (e.g. sa2) or a dynamic (LACP)
channel group (e.g. po2)
• a continuous range of interfaces, ports, static channel
groups or dynamic (LACP) channel groups separated by a
hyphen; e.g. vlan2-8, or port1.0.1-1.0.6, or sa1-2,
or po1-2
• a comma-separated list of the above; e.g.
port1.0.1,port1.0.2-1.0.4. Do not mix interface
types in a list
The specified interfaces must exist.
913