Remark New-Cos - Allied Telesis CentreCOM FS980M/9 Command Reference Manual

Q S C
O OMMANDS
-
REMARK NEW COS

remark new-cos

Overview This command enables you to configure and remark either or both of:
•
•
remark new-cos <0-7> [internal|external|both]
Syntax
no remark new-cos [internal|external|both]
Mode Policy Map Class Configuration
Usage The default CoS to Queue mappings are shown in the following table:
The relationship between this command and the CoS to queue map is shown in
the following figure.
613-50157-01 Rev C
the CoS flag in the data packet
the input into the CoS to queue map, thus changing the destination egress
queue.
Parameter Description
<0-7>
The new value for the CoS flag and/or the input into the CoS to queue
map.
external
Remarks the CoS flag in the packet.
internal
Remarks the new-CoS input into the CoS to queue map.
both
Remarks (with the same value) both the CoS flag in the packet and the
input to the CoS to queue map.
CoS Value 0
Egress Queue No 2
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
1 2 3
0 1 3
4 5 6
4 5 6
7
7
881