Allied Telesis CentreCOM FS980M/9 Command Reference Manual page 640

R C
OUTING OMMANDS
SHOW IP ROUTE
Figure 20-1: Example output from the show ip route command
Codes: C - connected, S - static, R - RIP, B - BGP
O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
* - candidate default

C 3.3.3.0/24 is directly connected, vlan1
C 10.10.31.0/24 is directly connected, vlan2
C 10.70.0.0/24 is directly connected, vlan4
C 33.33.33.33/32 is directly connected, lo
Connected Route The connected route entry consists of:
This route entry denotes:
•
•
Related ip route
Commands
maximum-paths
show ip route database
613-50157-01 Rev C
C 10.10.31.0/24 is directly connected, vlan2
Route entries for network 10.10.31.0/24 are derived from the IP address
of local interface vlan2.
These routes are marked as Connected routes (C) and always preferred
over routes for the same network learned from other routing protocols.
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
640