Allied Telesis CentreCOM FS980M/9 Command Reference Manual page 811

IP 4 S A C
V OFTWARE CCESS ONTROL
- ( )
ACCESS LIST EXTENDED NAMED
Table 25-5: IP protocol number and description (cont.)
Mode Global Configuration
Default Any traffic controlled by a software ACL that does not explicitly match a filter is
denied.
Usage Use this command when configuring access-lists for filtering IP software packets.
You can either create access-lists from within this command, or you can enter
access-list extended followed by only the name. Entering only the name moves
you to the IPv4 Extended ACL Configuration mode for the selected access-list.
From there you can configure your access-lists by using the commands
extended ICMP
protocol
Note that packets must match both the source and the destination details.
NOTE
Examples You can enter the extended named ACL in the Global Configuration mode
together with the ACL filter entry on the same line, as shown below:
awplus#
awplus(config)#
14 3.3.3.4/24 eq 12 log
613-50157-01 Rev C
L (ACL) C
IST OMMANDS
Protocol Number
89
97
98
108
112
134
135
136
137
138
139-252
253
254
255
filter), (access-list extended IP
filter).
: Software ACLs will deny access unless explicitly permitted by an ACL action.
configure terminal
access-list extended TK deny tcp 2.2.2.3/24 eq
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
Protocol Description [RFC]
OSPFIGP [RFC1583]
Ethernet-within-IP Encapsulation / RFC3378
Encapsulation Header / RFC1241
IP Payload Compression Protocol / RFC2393
Virtual Router Redundancy Protocol / RFC3768
RSVP-E2E-IGNORE / RFC3175
Mobility Header / RFC3775
UDPLite / RFC3828
MPLS-in-IP / RFC4023
MANET Protocols / RFC-ietf-manet-iana-07.txt
Unassigned / IANA
Use for experimentation and testing / RFC3692
Use for experimentation and testing / RFC3692
Reserved / IANA
filter), and
(access-list
(access-list extended IP
811