Allied Telesis CentreCOM FS980M/9 Command Reference Manual page 953

A C
UTHENTICATION OMMANDS
-
AUTH GUEST VLAN
The Guest VLAN routing mode in this release overcomes these issues. With the
Guest VLAN routing mode, the switch can lease DHCP addresses and accept access
to a limited network.
Note that Guest VLAN can use only untagged ports.
See the
for information about:
•
•
Examples To define vlan100 and assign the guest VLAN feature to vlan100 on interface
port1.0.2, and enable routing from the guest VLAN to other VLANs, use the
following commands:
awplus#
awplus(config)#
awplus(config-vlan)#
awplus(config-vlan)#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
To disable the guest VLAN feature on port1.0.2, use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
To define vlan100 and assign the guest VLAN feature to vlan100 on authentication
profile 'student', use the commands:
awplus#
awplus(config)#
awplus(config-vlan)#
awplus(config-vlan)#
awplus(config)#
awplus(config-auth-profile)#
To disable the guest VLAN feature on authentication profile 'student', use the
commands:
awplus#
awplus(config)#
awplus(config-auth-profile)#
Related auth profile (Global Configuration)
Commands
613-50157-01 Rev C
AAA and Port Authentication Feature Overview and Configuration Guide
Guest VLAN, and
restrictions regarding combinations of authentication enhancements
working together
configure terminal
vlan database
vlan 100
exit
interface port1.0.2
dot1x port-control auto
auth guest-vlan 100 routing
configure terminal
interface port1.0.2
no auth guest-vlan
configure terminal
vlan database
vlan 100
exit
auth profile student
configure terminal
auth profile student
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
auth guest-vlan 100
no auth guest-vlan
953