Priority-Queue - Allied Telesis CentreCOM FS980M/9 Command Reference Manual

Q S C
O OMMANDS
-
PRIORITY QUEUE

priority-queue

Overview Configures strict priority based scheduling on the specified egress queues. You
must specify at least one queue.
priority-queue [0][1][2][3][4][5][6][7]
Syntax
Mode Interface Configuration.
Usage
By default, the queues on all ports are set for priority queuing. You can change the
queue emptying sequence to weighted round robin, by using the
weight queues
the selected queues to priority queuing.
Note that the emptying sequence for priority queuing is always highest queue
number to lowest queue number.
Example To apply priority based scheduling to egress queues 1 and 2, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
Related show mls qos interface
Commands
wrr-queue weight queues
613-50157-01 Rev C
Parameter Description
[0][1]...[7]
Specify the queues that will use strict priority scheduling. With
strict priority scheduling, the switch will completely empty the
highest numbered queue first, then start processing the next
lowest numbered queue.
awplus(config-if)#wrr-queue weight 2 queues 0
% Queue weight changed for all ports
% All egress queues set to WRR scheduling
command. You can then use the
configure terminal
interface port1.0.1
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
priority-queue 1 2
wrr-queue
priority-queue command to reset
878