Show Mls Qos Interface Policer-Counters - Allied Telesis CentreCOM FS980M/9 Command Reference Manual

Q S C
O OMMANDS
SHOW MLS QOS INTERFACE POLICER

show mls qos interface policer-counters

Overview This command displays an interface's policer counters. This can either be for a
specific class-map or for all class-maps attached to the interface. If no class-map is
specified then all class-map policer counters attached to the interface are
displayed.
show mls qos interface <port> policer-counters [class-map
Syntax
<class-map>]
Mode User Exec and Privileged Exec
Usage Note that:
•
Example To show the counters for all class-maps attached to port1.0.1, use the command:
awplus#
Output Figure 27-5: Example output from show mls qos interface policer-counters
This output shows a policer configured with remarking through 'action remark-
transmit', so although bytes are marked as Red, none are dropped. Therefore, the
'Non-dropped Bytes' field shows a summation of Green/Yellow and Red bytes.
613-50157-01 Rev C
-
COUNTERS
The counters are based on metering performed on the specified class-map.
Therefore, the 'Dropped Bytes' counter is the number of bytes dropped due
to metering. This is different from packets dropped via a 'deny' action in the
ACL. If a policer is configured to perform re-marking, bytes can be marked
Red but are not dropped, and is shown with a value of 0 for the Dropped field
and a non-0 value for the 'Red Bytes' field.
show mls qos interface port1.0.1 policer-counters
awplus#show mls qos int port1.0.1 policer-counters 
Interface:
Class-map:
Green/Yellow Bytes:
Red Bytes:
Dropped Bytes:
Non-dropped Bytes:
Class-map:
Green/Yellow Bytes:
Red Bytes:
Dropped Bytes:
Non-dropped Bytes:
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
port1.0.1
default
0
0
0
0
cmap1
1629056
7003200
0
8632256
889