Allied Telesis CentreCOM FS980M/9 Command Reference Manual page 797

IP 4 H A C
V ARDWARE CCESS ONTROL
( ACL: TCP
NAMED HARDWARE OR
Then use this command (and the other "named hardware ACL: entry" commands)
to add filter entries. You can add multiple filter entries to an ACL. You can insert a
new filter entry into the middle of an existing list by specifying the appropriate
sequence number. If you do not specify a sequence number, the switch puts the
entry at the end of the ACL and assigns it the next available multiple of 10 as its
sequence number.
Then use the
to a port or QoS class-map. Note that the ACL will only apply to incoming data
packets.
You can use ACLs to redirect packets, by sending them to the CPU. Use such ACLs
with caution. They could prevent control packets from reaching the correct
destination, such as EPSR healthcheck messages and VCStack messages.
Example To add a filter entry to access-list named "my-list" that will permit TCP packets with
a destination address of 192.168.1.1, a destination port of 80, from any source, use
the commands:
awplus#
awplus(config)#
awplus(config-ip-hw-acl)#
Related access-group
Commands
access-list hardware (named hardware ACL)
match access-group
show running-config
show access-list (IPv4 Hardware ACLs)
613-50157-01 Rev C
L (ACL) C
IST OMMANDS
UDP )
ENTRY
access-group
configure terminal
access-list hardware my-list
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
or the match access-group
permit tcp any 192.168.1.1/32 eq 80
command to apply this ACL
797