Default-Action - Allied Telesis CentreCOM FS980M/9 Command Reference Manual

Q S C
O OMMANDS
-
DEFAULT ACTION

default-action

Overview Sets the action for the default class-map belonging to a particular policy-map. The
action for a non-default class-map depends on the action of any ACL that is applied
to the policy-map.
The default action can therefore be thought of as specifying the action that will be
applied to any data that does not meet the criteria specified by the applied
matching commands.
Use the no variant of this command to reset to the default action of 'permit'.
default-action [permit|deny|send-to-cpu]
Syntax
no default-action
Default The default is 'permit'.
Mode Policy Map Configuration
To set the action for the default class-map to deny, use the command:
Examples
awplus(config-pmap)#
613-50157-01 Rev C
Parameter
permit
deny
send-to-cpu
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
Description
Packets to permit.
Packets to deny.
Specify packets to send to the CPU.
default-action deny
856