Dot1X Keytransmit - Allied Telesis CentreCOM FS980M/9 Command Reference Manual

802.1X C
OMMANDS
1
DOT X KEYTRANSMIT

dot1x keytransmit

Overview This command enables key transmission on the interface specified previously in
Interface mode.
The no variant of this command disables key transmission on the interface
specified.
Syntax dot1x keytransmit
no dot1x keytransmit
Default Key transmission for port authentication is enabled by default.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port.
Usage Use this command to enable key transmission over an Extensible Authentication
Protocol (EAP) packet between the authenticator and supplicant. Use the no
variant of this command to disable key transmission.
To enable the key transmit feature on interface port1.0.2, after it has been
Examples
disabled by negation, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
To disable the key transmit feature from the default startup configuration on
interface port1.0.2, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
Validation show dot1x
Commands
show dot1x interface
613-50157-01 Rev C
configure terminal
interface port1.0.2
dot1x keytransmit
configure terminal
interface port1.0.2
no dot1x keytransmit
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
915