Auth-Web Enable - Allied Telesis CentreCOM FS980M/9 Command Reference Manual

A C
UTHENTICATION OMMANDS
-
AUTH WEB ENABLE

auth-web enable

Overview This command enables Web-based authentication in Interface mode on the
interface specified.
Use the no variant of this command to apply its default.
Syntax auth-web enable
no auth-web enable
Default Web-Authentication is disabled by default.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port; or Authentication Profile mode.
Usage Web-based authentication cannot be enabled if DHCP snooping is enabled by
using the
an IPv4 address for the VLAN interface on which Web Authentication is running.
Examples To enable Web-Authentication on static-channel-group 2, use the following
commands:
awplus#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
awplus(config)#
awplus(config-if)#
To disable Web-Authentication on static-channel-group 2, use the following
commands:
awplus#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
awplus(config)#
awplus(config-if)#
To enable Web authentication on authentication profile 'student', use the
commands:
awplus#
awplus(config)#
awplus(config-auth-profile)#
613-50157-01 Rev C
service dhcp-snooping
configure terminal
interface port1.0.2
static-channel-group 2
exit
interface sa2
auth-web enable
configure terminal
interface port1.0.2
static-channel-group 2
exit
interface sa2
no auth-web enable
configure terminal
auth profile student
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
command, and vice versa. You need to configure
auth-web enable
994