Allied Telesis CentreCOM FS980M/9 Command Reference Manual page 950

A C
UTHENTICATION OMMANDS
- -
AUTH DYNAMIC VLAN CREATION
If you issue an auth dynamic-vlan-creation command without a rule parameter
then a second supplicant with a different VLAN ID is rejected. It is not assigned to
the first supplicant's VLAN. Issuing an auth dynamic-vlan-creation command
without a rule parameter has the same effect as issuing an auth
dynamic-vlan-creation rule deny command rejecting supplicants with differing
VIDs.
The type parameter specifies whether multiple different VLANs can be assigned to
supplicants attached to the port, or whether only a single VLAN can be assigned to
supplicants on the port. The type parameter can select the port base VLAN or the
MAC base VLAN from the RADIUS VLAN ID. This can be used when the host-mode
is set to multi-supplicant. For single-host ports, the VLAN ID will be assigned to the
port. It is not supported with the Guest VLAN feature. Display the ID assigned using
a show vlan command. For multi-host ports, the VLAN ID will be assigned to the
MAC address of the authenticated supplicant. The VLAN ID assigned for the MAC
Base VLAN is displayed using the show platform table vlan command.
To configure Dynamic Vlan with Web Authentication, you need to set Web
Authentication Server virtual IP address by using the
command or the
create a hardware access-list that can be applied to the switch port interface.
You need to configure an IPv4 address for the VLAN interface on which Web
Authentication is running.
On the FS980 you cannot use the multi parameter and VLAN classifier rules on the
same port. VLAN classifier rules enable you to create Protocol-based VLANs.
The FS980M series switches do not support using IP subnet-based VLANs at the
same time as dynamic VLAN assignment of multiple supplicants
To enable the Dynamic VLAN assignment feature on interface port1.0.2, use
Examples
the commands:
awplus#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
awplus(config-if)#
awplus(config-if)#
awplus(config-if)#
613-50157-01 Rev C
auth-web-server dhcp ipaddress
configure terminal
interface port1.0.2
switchport access vlan 10
auth-web enable
auth dynamic-vlan-creation
interface vlan10
ip address 10.1.1.1/24
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
auth-web-server ipaddress
command. You also need to
950