Configuring The Fieldbus Controller Using The I/O Configurator - WAGO -I/O-SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
750-882 Media Redundancy ETHERNET Controller
9.1 Configuring the Fieldbus Controller using the I/O
Configurator
The I/O Configurator is a plug-in integrated into WAGO-I/O-PRO used to
determine addresses for I/O modules at a fieldbus controller.
1. In the left half of the screen for the WAGO-I/O-PRO interface, select the tab
Resources.
2. To start the I/O Configurator, double-click in the tree structure on Control
system configuration.
3. Expand the branch Hardware configuration in the tree structure.
4. Right-click on the entry K-Bus and then select Edit in the context menu.
5. In the "Configuration" window that then opens, click on Add to open the
module selection window.
6. Select the I/O module you wish to add from the module catalog and attach
it to the end of the local data bus structure by clicking on [>>] and OK.
7. Position all of the required I/O modules in their correct order until this
arrangement matches the configuration of the physical node.
Arrange the tree structure in the hardware configuration in the same manner.
Include all I/O modules which supply or receive data.
If you access your fieldbus controller online, you can use the [Start WAGO-I/O-
CHECK and scan] button in the "Configuration" window to read in the physically
linked fieldbus controllers with the series-connected I/O modules and display all
of the components.
The local data bus structure in the WAGO I/O Configurator must match the
physical node structure!
The number of I/O modules that send or receive data must correspond to the
existing hardware (except for supply modules, copying modules or end modules,
for example). For the number of input and output bits or bytes of the individual
I/O modules please refer to their corresponding descriptions.
Programming the PFC Using WAGO-I/O-PRO 129
Manual
1.5.0