Table of Contents
Advertisement
Running Card Tests
Self-Tests
Running Card Tests
Running a Card Self-Test
Step 1
Note
Cisco SFS 7000P Hardware Installation Guide
5-2
The Cisco SFS 7000P switch provides the following diagnostic tests:
Card Self-Test
•
Fan Self-Test
•
Power Supply Self-Test
•
The term "cards" in this section refers to fabric controllers, management I/O
modules, node cards, and the chassis ID module. Fans and power supplies are not
included in the card tests; they can be tested through the standard chassis test or
as individual components.
The following tests are available to locate and diagnose one or more cards in the
chassis:
LED
•
Self-test
•
To perform a diagnostic self-test on a card, follow these steps:
Enter the diag card number command.
SFS-7000P> enable
SFS-7000P# config
SFS-7000P(config)# diag card 11
SFS-7000P(config-diag-card-11)# test self-test
SFS-7000P(config-diag-card-11)# start
SFS-7000P(config-diag-card-11)# exit
SFS-7000P(config)# exit
You can stop the diagnostic self-test at any time by entering the stop command.
Chapter 5
Hardware Diagnostic Tests
OL-9167-01 Rev. A0
Advertisement
Table of Contents
