System Test-Preupgrade Running-Ver - Cisco Nexus 7000 Reference

Cisco Nexus 7000 Series NX-OS High Availability Commands
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m

system test-preupgrade running-ver

To test the running software version before an upgrade, use the system test-preupgrade running-ver
command.
Syntax Description running-version
target-ver
target-version
swid
software-id
impact
impact-number
Defaults None
Command Modes
Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History Release
4.0(1)
Usage Guidelines This command does not require a license.
Examples This example shows how to test the running software version before an upgrade:
switch(config)# system test-preupgrade running-ver 4.2<0.202> target-ver Update
swid 4.2.1 impact 0
System will be upgraded according to following table:
Module
------
OL-23374-01
system test-preupgrade running-ver running-version target-ver target-version swid software-id
impact impact-number
Running software version.
Specifies the target software version.
Target software version.
Specifies the software ID of the image running on a module. For example: system
or kickstart.
Software ID.
Specifies the impact. For example: 0 for hitless and 1 for hitful.
Impact number.
Modification
This command was introduced.
Swid Impact
---------- ----------
6 4.2.1 hitless
1
9 4.2.1 hitless
1
Cisco Nexus 7000 Series NX-OS High Availability Command Reference, Release 5.x
Running-Version
-------------------- --------------------
4.2<0.202>
4.2<0.202>
system test-preupgrade running-ver
New-Version Upg-Required
------------
Update
Update
HACR-23