C H A P T E; Configuring Ipv4 Acls; Finding Feature Information; Prerequisites For Configuring Ipv4 Access Control Lists - Cisco Catalyst 2960-X Security Configuration Manual

Configuring IPv4 ACLs

•
•
•
•
•
•
•
•
•

Finding Feature Information

Your software release may not support all the features documented in this module. For the latest caveats and
feature information, see Bug Search Tool and the release notes for your platform and software release. To
find information about the features documented in this module, and to see a list of the releases in which each
feature is supported, see the feature information table at the end of this module.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.

Prerequisites for Configuring IPv4 Access Control Lists

This section lists the prerequisites for configuring network security with access control lists (ACLs).
• On switches running the LAN base feature set, VLAN maps are not supported.
OL-29048-01
Finding Feature Information, page 139
Prerequisites for Configuring IPv4 Access Control Lists, page 139
Restrictions for Configuring IPv4 Access Control Lists, page 140
Information about Network Security with ACLs, page 141
How to Configure ACLs, page 154
Monitoring IPv4 ACLs, page 179
Configuration Examples for ACLs, page 180
Additional References, page 194
Feature Information for IPv4 Access Control Lists, page 195
Catalyst 2960-X Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX
10
C H A P T E R
139