Turning Off Specific Counter Monitoring
TX Datarate
------------------------------------------------------------------------------------------
Turning Off Specific Counter Monitoring
The following examples display turning off counter monitoring:
switch(config)# port-group-monitor name PGMON_policy
switch(config-port-group-monitor)# no monitor counter rx-datarate
switch(config)# show port-group-monitor PGMON_policy
Policy Name
Admin status : Not Active
Oper status
Port type
------------------------------------------------------------------------------------------
Counter
-------
TX Datarate
------------------------------------------------------------------------------------------
Activating a Port Group Monitor Policy
To activate a port group monitor policy, perform these steps:
Step 1
Enter configuration mode:
switch# configure terminal
Step 2
Activate the specified port group monitor policy:
switch(config)# port-group-monitor activate policyname
(Optional) Activate the default port group monitor policy:
switch(config)# port-group-monitor activate
(Optional) Deactivate the specified port group monitor policy:
switch(config)# no port-group-monitor activate policyname
Configuring Management Interfaces
Configuring the Management Interface Over IPv4
To configure the mgmt0 Ethernet interface to connect over IPv4, perform these steps:
Step 1
Enter configuration mode:
switch# configure terminal
Step 2
Select the management Ethernet interface on the switch and enter interface configuration submode:
switch(config)# interface mgmt0
Cisco MDS 9000 Series Interfaces Configuration Guide, Release 8.x
58
Delta
60
80
: PGMON_policy
: Not Active
: All Port Groups
Threshold
Interval %ge Rising Threshold %ge Falling Threshold
---------
-------- -------------------- ----------------------
Delta
60
100
Configuring Interfaces
10
80