Connect The Management Interface - Cisco CQ211L01-48H8FH Hardware Installation Manual

Connect Router to the Network
Step 8
The software asks whether you want to edit the configuration. Enter 'no' to decline.

Connect the Management Interface

The management port (MGMT ETH) provides out-of-band management, which lets you to use the
command-line interface (CLI) to manage the router by its IP address. This port uses a 10/100/1000 Ethernet
connection with an RJ-45 interface.
Caution
Before you begin
You must have completed the initial router configuration.
Step 1
Connect a modular, RJ-45, UTP cable to the MGMT ETH port.
Step 2
Route the cable through the central slot in the cable management system.
Step 3
Connect the other end of the cable to a 100/1000 Ethernet port on a network device.
What to do next
You are ready to connect the interface ports to the network.
Hardware Installation Guide for Cisco CQ211L01 Switch
32
To prevent an IP address conflict, do not connect the MGMT 100/1000 Ethernet port until the initial
configuration is complete.
Connect the Management Interface