Table of Contents
Advertisement
NAP-200-010
Sheet 3/7
System Initialization and
System Data Entry
To reset CAT mode:
While "COMMAND = -" is displayed on the LCD:
(1) Lift the handset (off hook)
- SPKR lamp turns off.
(2) Restore the handset (on hook)
- CNF, ANS lamps turn off.
- LCD returns to clock.
The 48-port Quick Install program allows the technician to set up the NEAX1000 IVS by completing a step-by-step
guide to install and program stations, line keys, and selective features into the NEAX1000 IVS. Additional program-
ming can be done using the CAT or MAT.
2.2 MAT
In addition to the CAT mode programming, the MAT can also be used in the MAT mode. Refer to the MAT Opera-
tion Guide and the Command Manual.
2.3 Feature Programming
This section provides the feature programming (Music On Hold, Push Button Calling) related to the internal PB Re-
ceiver and internal TNT on the MP card. For the other feature programming, refer to the Feature Programming Man-
ual.
In the programming procedure, the meaning of (1), (2) and marking are as follows:
(1) : 1st Data
(2) : 2nd Data
: Initial Data
With the system data clear command (CM00, CM01), the data with this marking ( ) is automatically assigned
for each command.
: System Initialization
INITIAL
After entering the data, system initialization is required (Press SW1 on MP card).
CHAPTER 3
Page 120
Revision 2.0
NDA-24219
Advertisement
Table of Contents
