Table of Contents
Advertisement
70
fig.
4.
58
Rear. fork
,
25X21
SPANNER
14 mm T TYPE BOX WRENCH
19 X 17
SPANNER.
,
l 4X 10 SPANNER
Fig. 4. 59
Tools required for disassembly ond assembly
of rear fork and rear fender
fig. 4. 60
Removing rear fork
Fig. 4. 61
Removing rear fork pivot bushing
4.
f RAM E
:l
• j
j
]
4.
10
Rear fork and rear fender
A,
Construction
9f
the rear fork
One end of the rear fork is fitted to a section of
the frame and the other end is fitted to the frame
through the rear cushion.
When the rear wheel
bounces, the section which is fitted to the frame-
becomes the rotation axis and the rear wheel bounces
in an arc.
Influence on the chain is quite small.
(Refer to Fig.
4.
58)
B.
Disassembly
1.
Tools required for disassembly and assembly of
the rear fork and fender. (Refer to Fig.
4.
59)
2.
Following Section
4.
13 B, separate the rear wheel.
3,
When two 6 X 1 0 hex baits and one 6 X 12
hex bolt are removed, the chain case is removed
from the frame.
4.
Following
Section
4.11 B,
separate
the
rear
cushion.
5.
When the 1 4 mm self locking nut is removed and
the rear fork pivot bait is removed, the rear fork
can be separated irom the frame. (Refer to Fig.
4.
60)
6.
Remove the rear fork center collar and the rear
fork pivot bushing by light tapping. (Refer to Fig.
4.61)
7.
By loosening two 6 X 12 and 12 X 1 8 hex baits,
the rear fender can be removed from the frame.
(Refer to Fig.
4.
62)
8.
By removing the 8 X 20 hex bolt and rear fork
pivot bait, the footrest bracket can be removed.
Disassembly of the rear fork is easily made if the
footrest bracket is removed.
C.
Inspection
l,
Measurement of the rear fork center collar.
I
Standard yolue
Correction limit
Ou!side
19.972
lo
19.993
mm
diameter
t.799
11
to
.7997
11
1
Bore
13.980
to
14.010
mm
(.559
11
to
.560
11
!
Overall
47.3
lo 47.4 mm
length
(J.89h
to
J.896
11
I
2.
Measurement of rear pivot bushing bore.
Standard value
Correction limit
Bore
20.05 to 20.08 mm
(.802
11
to .803
11
1
Hide quick links:
Advertisement
Table of Contents
