Rear Cowl; Rear Fender - Honda CB HORNET 160R 2015 Shop Manual

Table of Contents

Advertisement

REAR COWL

REMOVAL/INSTALLATION
While installing
Remove the rear garnish from both side (page 2-6).
the rear cowl
Remove the mounting bolts (4 nos.), collar (4 nos.),
route the
rubber (4 nos.).
wire harness
properly
Remove the screws (2 nos.) from the rear center cowl
(page 1-15).
and slide it backward to remove from rear cowl assembly.
Carefully release set lock cable from the left side rear cowl.
Assembly is in the reverse order of disassembly.
DISASSEMBLY/ASSEMBLY
Remove mounting screw (1 no.) from inner fender stay
While installing
from both side and remove both side rear cowl.
the rear cowl
route the
Remove screws (3 nos.) from inner fender stay and release
wire harness
rear tail light unit.
properly
(page 1-15).
Assembly is in the reverse order of disassembly.

REAR FENDER

REMOVAL/INSTALLATION
Remove the rear cowl (page 2-7).
Disconnect the turn signal and licence plate light wire
connectors.
Remove wire harness clamps (2 nos.).
Remove the bolts (5 nos.) and rear fender.
Installation is in the reverse order of removal.
FRAME/BODY PANELS/EXHAUST SYSTEM
REAR COWL
ASSEMBLY
MOUNTING
BOLTS
BRAKE TAIL
REAR
LIGHT UNIT
COWL
RIGHT
SCREWS
REAR FENDER
REAR COWL
CENTER
SCREWS
9 N.m (0.9 kgf.m, 6.6 lbf.ft)
INNER
FENDER
STAY
REAR
COWL
LEFT
BOLTS
2-7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents