Translation Update Test (#146) - Avaya S8700 Maintenance Manual

UDS1-BD (UDS1 Interface Circuit Pack)

Translation Update Test (#146)

The Translation Update test sends the circuit-pack-level information specified by
System Administration to the UDS1 Interface circuit pack. Translation includes
the following data administered for a UDS1 Interface circuit pack (see output of
display ds1 UUCSS command): DS1 Link Length between two DS1 endpoints,
Synchronization Source Control, All Zero Suppression, Framing Mode, Signaling
Mode, Time Slot Number of 697-Hz Tone, Time Slot Number of 700-Hz Tone, etc.
If a TN464F or later UDS1 circuit pack is combined with a 120A1 CSU module to
form an Integrated CSU module, this test will also send the administration for this
Integrated CSU to the circuit pack to assure the board's translations are correct.
The administration of the CSU module is done using the DS1 Circuit Pack
administration form. Translation for the CSU module includes the following data:
Transmit LBO, Receive ALBO, Supply CPE Loop-Back Jack Power?, etc.
Table 8-534. Test #146 Translation Update Test
Error Test
Code Result Description / Recommendation
ABORT Internal system error
1. Retry the command at 1-minute interval s up to 5 times.
FAIL Internal system software error.
1. Enter the display ds1 UUCSS command to verify the UDS1 Interface
PASS Translation data has been downloaded to the UDS1 Interface circuit pack
successfully.
0 NO The test could not relate the internal ID to the port (no board). This could be
BOARD due to incorrect translations, no board is inserted, an incorrect board is
inserted, or an insane board is inserted.
1. Verify that the board's translations are correct. Execute the add ds1
2. If the board was already administered correctly, check the error log to
3. If the board was found to be correctly inserted in step 1, then issue the
4. Issue the reset board command.
5. Issue the release busy board command.
6. Issue the test board long command.
This should re-establish the linkage between the internal ID and the port.
555-233-142
circuit pack translation.
UUCSS command to administer the UDS1 interface if it is not already
administered.
determine whether the board is hyperactive. If so, the board was shut
down. Reseating the board will re-initialize it.
busyout board command.
Continued on next page
Issue 1 May 2002 8-1277