Avaya S8700 Maintenance Manual page 195

PDMODULE (Processor Data Module) TDMODULE
(Trunk Data Module)
NPE Crosstalk Test (#9)
The NPE Crosstalk test verifies that this port's NPE channel talks on the selected
time slot and never crosses over to time slots reserved for other connections. If
the NPE is not working correctly, one-way and noisy connections may be
observed. If a secondary data module is assigned, it is tested after the primary
data module. If either test fails, both data modules are taken out of service. This
test usually run only during the long test sequence and takes about 20 to 30
seconds to complete.
Table 8-378. Test #9 NPE Crosstalk Test
Error Test
Code Result Description / Recommendation
1000 ABORT System resources required to run this test are not available. The port may be
busy with a valid call.
1. Use the display port UUCSSpp command to determine the extension of
2. If the port status is idle, then retry the command at 1-minute intervals up to
1001 ABORT System resources to run this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
1002 ABORT The system could not allocate time slots for the test. The system may be under
heavy traffic conditions or it may have time slots out-of-service due to
TDM-BUS errors.
1. If the system has no TDM-BUS errors and is not handling heavy traffic,
1003 ABORT The system could not allocate a tone receiver for the test. The system may be
oversized for the number of tone detectors present or some tone detectors may
be out-of-service.
1. Resolve any TTR-LEV errors.
2. Resolve any TONE-PT errors.
3. If neither condition exists, retry the test at 1-minute intervals up to 5 times.
1004 ABORT The port may be busy with a valid call.
1. Use the display port UUCSSpp command to determine the extension of
2. Retry the command at 1-minute intervals up to 5 times.
555-233-142
the data module port. Use the status data-module command to
determine the service state of the port. If the port is in use, wait until the
port is idle before testing.
5 times.
repeat test at 1-minute intervals up to 5 times.
the data module port. Use the status data-module command to
determine the service state of the port. If the port is in use, wait until the
port is idle before testing.
Continued on next page
Issue 1 May 2002 8-891