Avaya S8700 Maintenance Manual page 637

VAL-BD (Voice Announcements over LAN Circuit Pack)
Table 8-552. Test #600 Congestion Query Test
Error Test
Code Result Description / Recommendation
2000 ABORT Did not receive circuit pack test response within the allowable time period.
1. Retry command at 1-minute intervals up to 5 times.
2. If the problem persists, reset the circuit pack (reset board UUCSS).
3. If the problem persists, replace the circuit pack.
2012 ABORT Could not allocate the necessary system resources to run test.
2100 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the problem persists, escalate the problem.
1 FAIL The buffer level is nearly exhausted.
2 FAIL The VAL is congested, and no buffers are available.
1. Retry command at 1-minute intervals up to 5 times.
2. If command continues to fail, examine the VAL port measurements to
A Low processor occupancy when VAL is congested indicates circuit pack
failure.
1. If the problem persists, reset the circuit pack (reset board UUCSS).
2. If congestion recurs, replace the circuit pack.
High processor occupancy indicates the VAL is congested due to traffic load.
3 FAIL The VAL circuit pack is not operating normally and is congested.
PASS Hardware setting and attached cable type match VAL circuit pack
administration. The circuit pack detects no errors.
555-233-142
determine which ports are heavily utilized and the processor occupancy of
the circuit pack.
To relieve congestion in the short term, selectively busyout ports (busyout
port UUCSSpp) on the VAL circuit pack.
To achieve a more permanent resolution, it could be necessary reassign
announcements to other integrated announcement circuit packs.
Consider replacing affected VAL ports with new ports.
Continued on next page
Issue 1 May 2002 8-1333