Avaya S8700 Maintenance Manual page 407

TBRI-TRK (Trunk-Side ISDN BRI)
If no Maintenance/Test circuit pack exists, an outgoing test call over a trunk-side
ISDN-BRI facility is established over a high-speed data channel on the Network
Control (NETCON) circuit pack (DATA-BD).
Asynchronous Commands
NOTE:
Only one trunk can be tested in a given port network, until the test call is
canceled or completes.
Table 8-474. Test #258 ISDN Test Call
Error Test
Code Result Description / Recommendation
4 ABORT There is a problem with the Processor Interface Link.
1. See the PI-LINK (Processor Interface Link) Maintenance documentation.
1004 ABORT B channel in use.
1. Issue the status trunk command to determine whether a call is active on
2. When the service state indicates in-service/idle, retry the test.
1005 ABORT Bad Configuration (that is, no Maintenance/Test circuit pack)
Issue the test trunk <trunk Group/trunk member> command and make
sure there is a DATA-CHL (NETCON channel) administered.
1018 ABORT Test call is disabled.
1. Enable Maintenance on the Trunk Group form.
1024 ABORT (M/T-DIG) Maintenance/Test Digital Port in use.
1. Wait until yellow and green LEDs are turned off on the M/T-BD
2. Retry the test. If problem persists, see
1113 ABORT The signaling link has failed; the system cannot send any messages on behalf
of this trunk.
1. Check the results of Test #1251 (Signaling Link State Check Test).
1114 ABORT The signaling link is in a transitional state.
1. Retry the command at 1-minute intervals up to 5 times.
1116 ABORT The switch could not appropriately change the ISDN service state.
1. Issue the status trunk command to determine whether a call is active on
2. If not, check the error and alarm logs for problems with this TBRI-TRK MO.
555-233-142
this trunk-side ISDN-BRI channel.
(Maintenance/Test circuit pack).
Digital Port)'' on page 8-834.
this trunk-side ISDN-BRI channel.
''M/T-DIG (Maintenance/Test
Continued on next page
Issue 1 May 2002 8-1103