Avaya S8700 Maintenance Manual page 415

TDM-BUS (TDM Bus)
In Procedure 2, an option of working either with one circuit pack at a time or with
multiple circuit packs simultaneously is available. In view of this capability,
determine the level of service interruption that will be acceptable during the
procedure. If causing a disruption to all users in the port network is deemed
permissible, large groups of circuit packs should be worked with in order to get the
job done quickly. However, if large service disruptions are to be avoided, work
with one circuit pack at a time. This option is slower, but it disrupts only the users
of a single circuit pack.
1. Remove one or several circuit packs as appropriate. Any circuit packs that
reside on the TDM bus that have been recently inserted should be checked
first.
If you decide to remove multiple circuit packs, consider working with an
entire carrier at a time to more quickly and reliably determine which circuit
packs are not the source of trouble.
2. Run test tdm P to determine whether the TDM-bus fault is still present.
3. If any of the TDM-bus tests fail:
4. If none of the TDM-bus tests fail:
Continue with Procedure 3 if every port circuit pack has been checked, but the
TDM-bus fault is still not resolved.
555-233-142
Determine whether the backplane pins in the removed circuit pack's
slot appear to be bent.
If the backplane pins are not bent, reinsert the circuit pack(s), and
perform Procedure 2 for the next set of circuit packs.
If the backplane pins are bent, remove power to this carrier in the
manner described previously.
Straighten or replace the pins and reinsert the circuit pack.
Restore power and repeat Procedure 2, beginning with Step 2, for
the same circuit pack(s).
Reinsert the circuit pack(s) one at a time, and repeat the following
substeps until every circuit pack has been reinserted.
Run test tdm P to determine whether the TDM-bus fault has
returned.
If any of the TDM-bus tests fail, the reinserted circuit pack is
defective. Replace this circuit pack and repeat this procedure for
the next circuit pack.
If none of the TDM-bus tests fail when every circuit pack has been
reinserted, the problem has been fixed and the procedure is
completed.
Issue 1 May 2002 8-1111