Avaya S8700 Maintenance Manual page 276

Avaya s8700 media server for ip connect configurations
Hide thumbs Also See for S8700:
Table of Contents

Advertisement

Maintenance Object Repair Procedure
Table 8-409. Test #1281 TCP/IP Ping Test — Continued
Error
Test
Code
Result
Description / Recommendation
2100
ABORT
Could not allocate the necessary system resources to run test.
1. Retry the command at 1-minute intervals up to 5 times.
2. Escalate if the problem persists.
2500
ABORT
Internal system error.
1. Retry the command at 1-minute intervals up to 3 times.
2. Escalate if the problem persists.
1003
FAIL
Ping to the destination failed due to on-board problem.
1. Retry the command at 1-minute intervals up to 3 times.
2. If the problem persists, reset the circuit pack (busyout board UUCSS,
3. If the problem persists, re-administer the PPP connection through a
4. If the problem still persists, or if there are no other available PPP ports,
1007
FAIL
Ping to the destination failed due to the destination down.
1. A PPP destination or a component in the path (e.g., DS1 trunk) may be
2. If the destination and every component in the path is in-service, ping the
3. Escalate if the problem persists.
PASS
TCP/IP Ping test (#1281) is successful.
Session Status Test (#1286)
This nondestructive test determines the status of every PPP port session. This
test queries the system software on port session status.
If the system software indicates that:
Every port session is up (ALL UP)
Some port sessions are up (SOME UP)
Every port sessions is down (ALL DOWN)
8-972
Issue 1 May 2002
reset board UUCSS, and release board UUCSS).
different PPP port, if available.
replace the circuit pack.
down. Check the status of the destination or other components in the path.
PPP destinations (ping ip-address xxx.xxx.xxx.xxx).
Continued on next page
Then the switch:
Raises no alarm, or retires alarm
Raises MINOR alarm
Raises MINOR alarm
555-233-142

Advertisement

Table of Contents
loading

Table of Contents