Avaya S8700 Maintenance Manual page 156

Maintenance Object Repair Procedure
Packet Bus Port Health Inquiry Test (#567)
This test verifies that the packet-bus fault-detection and maintenance function of
the M/T-PKT is functioning properly. This is done by having the M/T-PKT perform
a self-test. If the self-test passes, then the Packet Bus Port Health Inquiry test
passes. If the self-test fails or the SPE cannot communicate with the M/T-PKT,
then the test fails
Table 8-363. Test #567 Consistency Test
Error Test
Code Result Description / Recommendation
2000 ABORT Response to the test request was not received within the allowable time period.
2100 ABORT System resources necessary to run this test are not available.
2500 ABORT An internal operation failed, and the test could not be completed.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort, escalate the problem.
2059 FAIL The M/T-PKT has reported a failure of the on-board self-test.
2060 FAIL The M/T-PKT has reported an invalid state for the packet bus.
2061 FAIL The SPE cannot communicate with the M/T-PKT, but can communicate with
the Maintenance/Test circuit pack.
1. Retry the command.
2. If the test continues to fail, replace the Maintenance/Test circuit pack, and
3. If the test continues to fail,
PASS The M/T-PKT packet-bus fault-detection capability is operating correctly.
8-852 Issue 1 May 2002
retry the command.
determine whether the M/T-PKT failure is being caused by a packet-bus
fault.
see''PKT-BUS (Packet Bus)'' on page 8-918
Continued on next page
to
555-233-142