Avaya S8700 Maintenance Manual page 379

TBRI-BD (TN2185 ISDN Trunk-Side BRI)
Table 8-459. Test #595 LAN Receive Parity Error Counter Test
Error Test
Code Result Description / Recommendation
2000 ABORT Response to the test was not received from the circuit pack within the allowable
time period.
1. If the test aborts repeatedly up to 5 times, reset the circuit pack via the
2. If the test aborts again, replace the circuit pack.
2100 ABORT Could not allocate the necessary system resources to run this test.
2012 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
1–10 FAIL The circuit pack is still detecting errors of this type. The error code indicates
the value of the on-board error counter.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to fail, verify the validity of the Packet bus. Run the
3. If the Packet bus test passes, check the validity of the circuit pack.
4. Other circuit packs on the Packet bus may be causing of the parity error.
PASS No errors detected.
555-233-142
busyout board UUCSS and reset board UUCSS commands.
Packet bus maintenance test with the test pkt P long command. If any
Packet bus tests fail, see
recommended repair procedures.
Execute a test that involves data transmission onto the Packet bus. For
example, the test port UUCSSpp command may use the connectivity
tests of the BRI-PORT MO. If the test fails, refer to the repair procedures;
otherwise, proceed to the next step.
Use the display errors command to check the Error Log for alarmed other
circuit packs. Resolve any alarms for other circuit packs as well. Rerun
the LAN Receive Parity Error Counter test (#595).
''PKT-BUS (Packet Bus)'' on page 8-918
Continued on next page
Issue 1 May 2002
for
8-1075