Avaya S8700 Maintenance Manual page 455

TIE-DS1 (DS1 Tie Trunk)
Table 8-489. Test #136 DS1 Tie Trunk Seizure Test — Continued
Error Test
Code Result Description / Recommendation
2000 FAIL Response to the seizure message was not received within the allowable time
period.
1. Enter the list configuration board UUCSS command. If the circuit pack
2. Verify that the 'Trunk Type' field on the 'Trunk Administration' screen
3. Look for DS1-BD or UDS1-BD errors in the hardware error log. If present,
4. Retry the test at 1-minute intervals up to 5 times.
PASS The trunk can be seized for an outgoing call.
0 NO The test could not relate the internal ID to the port (no board). This could be
BOARD due to incorrect translations, no board is inserted, an incorrect board is
inserted, or an insane board is inserted.
1. Check to ensure that the board's translations are correct. Use the list
2. If the board was found to be correctly inserted in step 1, issue the busyout
3. Issue the reset board command.
4. Issue the release busy board command.
5. Issue the test board long command. This should re-establish the linkage
1. Earlier G1 Software Versions reported Error Code 2053 as a FAIL
555-233-142
is a TN767B vintage 8 or 9, a failure of test 136 causes a subsequent
failure of test 7 due to a firmware bug. Eventually, the board and all of its
ports are taken out of service, and extraneous on-board alarms are
generated. Replace the circuit pack with a TN767C V3 or later.
matches the trunk type administered on far-end switch.
see the ''DS1-BD (DS1 Interface Circuit Pack)''
Interface Circuit Pack)'' maintenance documentation.
config command, and resolve any problems that are found.
board command.
between the internal ID and the port. If this is not the case, check to see
that there is a valid board inserted.
or ''UDS1-BD (UDS1
Continued on next page
Issue 1 May 2002 8-1151