Avaya S8700 Maintenance Manual page 53

MEDPRO (Media Processor MAPD Circuit Pack)
SAKI Sanity Test (#53)
This is a destructive test.
This test is only run as a part of a reset board procedure. For the Media
Processor, it is necessary to use the change ip-interfaces form to disable the
Media Processor IP interface before performing this reset board procedure. Other
common circuit packs can be reset with the reset board UUCSS command which
also executes this test.
A reset of this circuit pack will take about 3½ minutes.
Table 8-317. Test #53 SAKI Sanity Test
Error Test
Code Result Description / Recommendation
None ABORT System resources required for this test are not available.
1015 ABORT Port is not out-of-service.
2100 ABORT System resources required for this test are not available.
2803 ABORT It is necessary to reset the board.
1 FAIL The circuit pack failed to reset.
2 FAIL The circuit pack failed to restart.
PASS The circuit pack initializes correctly.
Any NO This is normal if the test is being done when (a) the board is not physically in
BOARD the system or (b) the system is booting up. Otherwise, there is some
inconsistency between the physical configuration and the data kept in the
system.
555-233-142
1. Retry the command at 1-minute intervals up to 5 times.
1. Busyout the circuit pack.
2. Execute command again.
1. Retry the command at 1-minute intervals up to 5 times.
1. Use the change ip-interfaces form to disable the Media Processor IP
interface.
2. Execute the command again.
1. Execute command again.
2. If the problem persists, replace the circuit pack.
1. Run the short test sequence.
1. Verify that the board is physically in the system.
2. Verify that the system is not in a stage of booting up.
3. Retry the command at 1-minute intervals up to 5 times.
Continued on next page
Issue 1 May 2002 8-749