Avaya S8700 Maintenance Manual page 492

Maintenance Object Repair Procedure
Error Log Entries and Test to Clear Values
Table 8-505. Tone Generator Error Log Entries
Error Aux
Type Data Associated Test
1
0 0 Any
1 (a) 17664 Tone Generator Audit/
Update test (#41)
18 (b) 0 busyout tone-clock UUC
130 (b) None
257 (c, e) 17667 None
513 (d, e) 17666 Tone Generator Audit/
Update test (#41)
769 Any Transmission test (#40)
1025 Crosstalk test (#90)
1281 (f) Any Tone Generator Audit/
Update test (#41)
1. Run the short test sequence first. If every test passes, run the long test sequence. Refer to each appropriate
test's description, and follow its recommended procedures.
Notes:
a. A failure in the tone generation facility on the indicated circuit pack has
been detected. Replace the circuit pack. See
Pack'' on page
b. This error type indicates that the circuit pack has been removed or has
been insane for more than 11-minutes. To clear the error, reinsert or
replace the circuit pack.
c. The tone generation facility is having problems verifying that tones have
been connected as requested.
d. The tone generation facility may or may not be able to generate tones.
e. Infrequent errors, at a rate which does not bring up an alarm, probably do
not affect service, unless there are customer complaints of no tones, or
incorrect tones which can not be explained in any other way. However, if
an alarm is raised because this error is being repeatedly logged, then the
circuit pack should be replaced. See
page
8-1188 Issue 1 May 2002
8-1177.
8-1177.
Alarm On/Off
Level Board Test to Clear Value
Any Any test tone-clock UUC r 1
MAJOR ON test tone-clock UUC r 2
WARNING OFF release tone-clock UUC
MINOR ON test tone-clock UUC Sh
MINOR ON
MINOR ON test tone-clock UUC r 3
MAJOR ON test tone-clock UUC r 3
MAJOR ON test tone-clock UUC l r 2
MINOR ON test tone-clock UUC r 3
''Replacing the IPSI Circuit
''Replacing the IPSI Circuit Pack'' on
555-233-142